analogmascon [ ]

この文書は読取専用です。文書のソースを閲覧することは可能ですが、変更はできません。もし変更したい場合は管理者に連絡してください。

====== Using analog PWM controller ======

===== About this =====

DSmain has an interface of analog PWM. You can connect your analog PWM controller to DSmain.
The structure shows as the following.

{{http://buin2gou.sakura.ne.jp/sblo_files/powerele/image/MasconCnv_06-thumbnail2.png}}

The schematic is the below. This schematic applies to DSmain.

{{http://buin2gou.sakura.ne.jp/sblo_files/powerele/image/MasconCnv_02-thumbnail2.png}}

===== How to connect =====

If you have [[http://www.tomytec.co.jp/diocolle/lineup/tetsudou_seigyo/index.html|JR101 analog controller]], you can setup like the following.

{{http://buin2gou.sakura.ne.jp/sblo_files/powerele/image/MasconCnv2_02-thumbnail2.jpg}}

You need 2 jumper wires to connect between DSmain and the analog controller.

{{http://yaasan.mints.ne.jp/gateway/figures/DSMR2_PCB9_thm.jpg}}

===== How to control =====

You need to upload the supported sketch to the DSmain. The sketches are DSmainRx.

{{http://buin2gou.sakura.ne.jp/sblo_files/powerele/image/MasconCnv2_07-thumbnail2.jpg}}